Finally tried starting my 302 up last night after sitting for months and months. Gas is likely bad. What’s the best way to drain the tank (half...
Thanks! That’s a beautiful picture. I got them routed. I’ll come up with some clamps that’ll work and then see what happens. I’m going to cover...
Anyone know how the pump to control valve hoses route? I snuck them by the engine mount and they rest on the oil pan and have a terribly not...
I've got a line on a complete 5.0 roller from a 95 Mustang along with the T5 that came with it. Would this be a decent candidate to take apart,...
Great, thank you! Put it on with 4 threads left and looks about right to me. We'll see when I finish connecting it and pressure it up.
I was reading through Randy's site about the control valve and all that and he mentioned following a specific measurement for how far to thread...
Yessir I think that'll help!
I completely took apart the PS on my 77 302 and sent the big 3 (pump, control valve, power cylinder) off to Randy to be rebuilt and painted. I’ve...
I am about to order a new ring and pinion to get some better low speed performance. While I'm in there, what else should I just go ahead and...
I'm relatively certain I have the 268h cam (I recall seeing a picture of the box years ago) which would imply hydraulic flat tappets. Is it worth...
So I’ve learned! There was definitely a miscommunication somewhere down the line when I got this maverick. Fun learning about it!
Sounds like not a good block to build up with the raised deck
Picture attached
Looks like block is E5AE G3B 8 that G could be a C. Not totally sure
I will check them when I get home. I'm never so lucky so I'm sure I have a run-of-the-mill block.
Thanks for that input! I had seen the mustang guys refer to the 185 heads pretty often so at least we're talking the same language. I don't know a...
Hey y'all, Here's my setup: 79 302 block from a Granada, bored .030 over, installed in a 77 Unsure what pistons or rods Comp 268h cam Stock heads...
Is it even possible? Most of the build threads I've found are manual steering. Curious if anyone's done it and if it was worth it.
Thanks yall! I’m going to pass. And to clarify I don’t mean a “stroker ready” block in that way. But still need a good foundation. My current...
Im wanting to replace the 79 302 (306) in my 77 with a roller block that I’ll stroke to a 347 properly. Is this a good starting point? I’ve never...
Separate names with a comma.
