Good Morning Y'all, I'm going to work on changing my rear end gear ratio. I don't think I'm going to do it myself because I never have and don't...
Anyone gotten the passenger side one cut convex? My flat piece is 100% worthless.
Got it all fixed. Alternator light does work as described. [ATTACH]
Got it all wired up today. So far I've only seen one fan speed. I may manually trick it instead of the temp sensor so I know what each sounds...
Mine is a 195/210. It says it in celcius real small I found out
Not completely sure. It's a bmw one that came with my Volvo controller from ebay
yep, temp sensor
Yes it is
I know there are 100 threads on this but it's taken a while to aggregate the information. I just wanted to check that what I am planning looks...
You are absolutely right. It took some time but I figured out what my setup is. I have an aftermarket hi-torque starter so that solenoid that I...
Hey Guys, Today I spent the 2 hours (including beer breaks) replacing my factory 40-amp 1G with a 3G from a 95 Ford Taurus. I believe it's a...
Got it started after verifying I had spark, plugs weren't fouled, and injected fresh has with a syringe right into the carb. Ran rough until the...
I upgraded my intake and carb to a Weiand Stealth and a Holley 650. It ran perfectly fine for a while after that and then in November I parked it...
Yeah there's one on the nut side of the bolt too which doesn't make a ton of sense to me. That one has become fused to the bolt over the years I...
Hey guys, I'm rebuilding my front end using a PST kit ( but with rubber torque rod bushings) and ran into a snag. The camber adjustment lobes...
Thanks but I used the rubber band trick to keep it in the pocket until the bolts were torqued. No dice. Going to try with no paper gasket next but...
Is it possible that your distributor doesn't have the giant vacuum advance assembly on the front? That's really what gets in the way not allowing...
Heh. What I was doing was making it harder on myself by trying to do it without removing the distributor again. I did it to myself! :coco: I was...
Well I got a Felpro thermostat housing gasket, new thermostat (again) and some permatex 518 to seal the gasket. Putting that housing back on was...
Makes enough sense. Will replace that tomorrow and work on the kick down. I got that bushing installed for the throttle cable and it feels like...
Separate names with a comma.
