250 with a Vortech Supercharger !!! neat, love it !!!
Boyds, junk yard dogs.
I voted 5.0L roller oem cam or with these upgrades for fun ;a 85 5.0L cam(you can keep the oem valtrain) if no emission checks required e-cam or...
try the stock bearings first. use 30w oil for assembly on the mains. torque to spec and spin test. should have a little resistance. check end...
x2 while the crank and rods are at the machine shop, check cam bearings and galley oil plugs....
I run 295x50x15 on both maverick that I own, 8 inch wide wheels and 4" backspace.BTW not M/T et's.... but,295 do fit with the right back spacing...
#1- change the batterry out (borrow) and eliminate that possibility of a dead cell or broken batt. post... #2- clean your batt. terminals/clamps...
you can use a digital back dial timing light(beg , borrow or purchase ) to check and adjust your timing. as for exhaust, any strait true more or...
sounds like a restriction in the fuel line/filter,blow compressed air tru the fuel line and remove the gas cap so it can vent out.make sure your...
cool... car... great win !!!! any close calls thru the eliminations, on your way to victory ????
when I first installed the hydraulic ram drop braket, I could see it move. a week later took it to the muffler shop and had it welded to the frame...
looking good !!!! In my neck of the woods I saw the cowl and grabber hood mod made in steel, perfect blend and smooth lines. could not tell it was...
mine was a 250cid, with the 91 5.0 hyd. roller the ride height stayed the same:(... there is a spring cut on the drawing board...
I have changed out 3 control valves and none had that roll pin installed... now with that out the way... try to screw a small easy-out and see if...
here is a picture of the ball joint seperator..... the small one on the top left hand coner slides in just right...
use a ball joint puller, it's smaller than the pitman arm puller and it fits on the stud perfect.... now the trick part is to align CV stud, JB...
I say about 100amp at high idle, 60 amps at low idle minimun.... or the 3g conversion like I did on the 63 fairlane (150 amps max output) very...
if you can get someone that makes high-pressure hydraulic lines and have them crimped t o the fittings it would be safe/sano install.... I try to...
I would try a " T " fitting on the front bowl and a 90 degree elbow fitting on the rear bowl and 3/8 fuel hose in between.... once you have the...
cool !!!! great launch !!!! I wish mine would stick like that !!!!!
Separate names with a comma.
