I'm lost I bleed many times and pumped fluid in from the bottom. I have adjusted it where it has a crap load of pressure on the fingers and it...
It has alot of fingers. I would say 10 or so.
All i can say is that i had an aod in mine for a while and i use the same driveshaft with the same yoke. I didn't change anything.
Anybody???????
I need some shooling. What is that? So mine should not touch? I have fingers .
I was just on a mustang forum reading and they said fords bearing was designed to ride against the cluch fingers. IS THIS TRUE ? I can get my t5...
I read in the internet a guy said to hook a hose up to the bleeder (on the slave ) and the other end of the hose to a small oil can ( pump style )...
Im using stock pedals. And right now i removed the push rod and had my wife push the clutch pedal. The piston comes all the way to the end but...
I can't seem to get enough travel on the shift fork. I've tried bleeding at the slave and at the master cylinder. I can preload the cluch and get...
My bad i ment drum. It doesn't matter now i just got them and the drums are 1 inch bigger than what i i have on their now. Back to the drawing board.
What i ment was where the rotor ( the shaft where the wheel bearings go ) fits on the spindle. So the shaft is different as well?
Ok thanks for the info.
So the spindle is ok, i just check out what you said and im good?
Are you talking about the diameter of the drum? If not what do i measure? Thanks
Anybody?????????
Will 65 mustang 5 lug drums fit on a 72 comet ?
Filled the t5 trany , filled the radiator and set the timing. Hopefully take it for a drive after 3 years of sitting . Took me a little longer to...
Welcome to the board.
Got my new throttle plate with springs on and hooked up my throttle cable.
Really nice looks good.
Separate names with a comma.
