my son's serp setup cost $20 at the junkyard. or check the alignments on all pulleys, & think about a retainer fixture on the long side of the belt.
towed a 2500# car last weekend on a dolly with an e150 van in pa. 150 miles up & down hills. no dolly brakes; no problems stopping. just leave...
i have been told that flat towing an auto trans car will generate heat in the trans & without the pump being turned by the engine to pump thru the...
just wondered if anyone on here was going next week?
one of the rear cables frozen. or both are. have someone put parking brake on while u watch to see which cable (s) wont move.
yes u can. air line that screws into spark plug port to hold valves closed with air pressure, valve spring compressor that works when head is on car.
which flexplate did you use? the 250 plate is internal balance; cannot use it even tho it bolts on.
i thought aod had a lower 1st gear. doesnt it? my error.
generally looser will help traction. cutting that coil also stiffened the spring rate which can hurt. if the front end has a lot of travel &...
the pinto was specifically a problem with the tank being shoved into the differential & causing a spark to go with the tank rupture. the fix was...
friend of mine tried one. wasnt happy with results. the regular offy 360 was pretty good, tho.
closest to front is out to cooler. closest to rear is return.
this is just my opinion, & will probably cause some disagreement, but do you have any traction bars or control arms in the rear? when u bounce...
long time ago a tech guy told me why the top must be the disconnect. if you try to stage without fastening the net, its obvious, cause the net...
nice looking work.
section 6.3 the permanet attachment must be at the bottom of the net. sounds like you want to put a disconnect (carabiner) at the bottom, if i...
i started with 289s & later went to 302s & 351s. go with the 302. the 289 parts that are unique can be hard to find, the main caps are very...
where are you putting the bottom mount? bottom mount must be permanent. how will you put it to a swingout bar? have both ends of top bar pop...
for .500 start at .047. for .400 turn the box off. dont just set .000. if the box is powered up it can still cause a slight delay, except maybe...
i just got a 302 dist & dropped in the motor. no problem.
Separate names with a comma.
