i welded up a plate that replaces the saddle on one of my hydraulic jacks. lower it and trans down, slide trans off plate onto ground and slide...
fairly sure it is 16 gal. my 74 comet was 16 & so is my 75 mav.
when i swapped out my toploader for a c4 i used the same yoke (and same driveshaft), but all i was changing was the trans.
what did tci say? if fluid not an issue, sounds like a valve body problem. maybe button, but the rpm relationship sounds like you nrrd some...
i think hard blok claims can be used after machining of cyls is done, but dont know for a fact. obviously track only, you need either a killer...
first, there is no divider inside the engine. vac at one valve cover affects the other. most '60-'70s setups involve one vc going to carb, one to...
also dist cap, rotor, fuel filter (probably mounted on the frame), air filter.
74 4 door. 3250 with full tank, alum intake, no ac, no ps, alum wheels.
east coast electric. they make them for race cars, so they seem to survive the higher rpm usage better. its a 1 wire. had it 13 yrs, still...
never started, but dipstick red hot? sounds like a short or bad ground to me.
also, some of the aftermarket dampers, the not sfi ones, often have a suggested rpm limit. if you think in the future you would need/use an sfi...
the balance shop can match weight it. just like if you get a new flexplate/flywheel.
most of the engines we use are how old? including oem dampers. anyone whose motor is going much over 6000 rpm should really think about an...
make it strong. i think there will be more than 100 lbs of stress on it as you go down the road. jmho.
great season. congratulations.
is the pinion in a 8" mav centered in the car? i believe the early bronco 9" is 3/4" off center. if there is a small offset, will it matter?...
mav 5946 - why arent u using a block/starter plate? i dont see one in the pics. that plate is what locates the starter. without it the starter...
it defrosts just fine without a/c. i've gone thru 2 winters so far with no problem. the defrosters worked well in cars long before a/c became a...
i got one of those little dimples too, don. lol
the main stud maker and girdle manufacturers should have supplied torque specs.
Separate names with a comma.
