I just realized that I will have to wait on the timing chain and save it for another day! I have spent well over a few hundreds of dollars for...
I bought mine off of summitracing, its a ford oem timing cover! But on that timing chain what is a good one to buy?
So here is a good/ bad news report! Good news: I don't have to worry about the bolt anymore! Bad news: The timing cover cracked due to the heat...
I would weld it but the welder I have is cheap and I'm still figuring it out!
So I tried heating it up and it didn't work, if anything it made it worse! As much as I want to drill it out I don't know if I should. Drilling it...
Guess what I broke another bolt, again!! Alright in all seriousness the broken bolt is from the timing cover and I have been informed that this is...
Does anyone know how to remove a broken anchor pin from a sun-visor? I tried but a made it worse!
I hope you don't mind but can I see a picture(s) of the flex fan in your Maverick?! I have a similar fan and I want to make sure I have it install...
PLEASE READ THE ENTIRE PASSAGE I NEED TO KNOW WHAT IS HAPPENING! I DON'T KNOW HOW CONFUSING THIS MAY SOUND BUT PLEASE TRY TO UNDER STAND WHAT I...
After start up the engine overheats around 15-20 minutes both running and while it idles. It's fine at high rpm but at low rpm it overheats...
No my upper hose is ALWAYS hotter than the lower hose by 20-30 degree and the I have a spring in the lower hose and coolant runs through it just fine!
It is the original engine and has never been rebuilt, at least to my knowledge. Yes it overheated 30 minutes after I bought it, it was about 45-an...
So I am about was is to be my last option into solving my overheating problem! I have replaced the radiator, heater core, hoses, and thermostat; I...
I finally have everything set! both engine and trans oils are changed, no leaks and no more broken bolts! However, I am experiencing a new problem...
Thank You to all of you! I bought the easy-out set and used a center punch to mark where to drill. As soon as I began to use the smaller drill but...
There was silicon already around the pan lip before I took it off. I know that I Need to get that bolt out but I don't know how, that's what I am...
So I decided to do an oil change for the motor and transmission the other day, the engine oil change was easy and fast; however, the transmission...
Cool Thank you! I also realized that I had forgotten to ask if anyone knew if there is a place that makes the kick panels for the rear? I don't...
Does anyone know where I can get new kick panels at, preferably in black (if there is a place)? I want to know before I decide to paint the ones I...
Nevermind I figured it out when I went to get my overheating issue checked. The mechanic told me where and what to check and it turns out the the...
Separate names with a comma.
