I never did get the B&M kitted tranny to the track to get an accurate measure of performance, but the B&M just shifted harsh. Like BANGED from...
Pay real close attention to where things are BEFORE and during disassembly. in the instructions for the B&M shift improver kit it says make sure...
thanks for the info folks, a couple more questions came up with your replies however. How easy is it to get your plugs in? On a Chevy Nova my kids...
has anyone ever seen or heard of a set of headers that would fit a Mav, Falcon, early Mustang or some similar type car with gt40p heads? I...
not carved in stone but C-4 2.46 or 2.47 (1st), 1.46 or 1.47 (2nd) 1.00 (3rd) AOD 2.40 (1st) 1.47 (2nd) 1.00 (3rd) .67 (4th) Later AODE's had...
Just wondering, if you say you have to beat the headers in and that they exit in the wrong place, ETC. do you have the right headers?
also let it idle for a while after idling since you'll be pouring ATF down the dipstick tube, if you check the level too soon after adding it will...
Just wanted to add my .02. took stock motor out my 77 mav put different oil-pan on it to fit into a fox-platform mustang, home ported the exhaust...
Has anyone heard of putting an 289 crank in a newer block that has a one piece seal? I was thinking as good as my roller cam engine revs it could...
Thanks, that is exactly what I wanted to know. You people in this forum are awesome!
Anyone know offhand what the flange to flange width is for a mav with a stock 8"? I guess I'm just being lazy and don't want to crawl under and...
I would also like a set of those when you get them done, and since my car is still in the some day stage I'm not in a hurry. So what's the count...
bhrivers, you never mentioned if you have a manual or auto tranny, but the 2.3 bell is different from 250's. if you still want to do this swap...
If I were going to try it I would use a setup from a Thunderbird turbo coupe or a turbo GT Mustang since the SVO is a special car and has a few...
Hey all, I measured the rear from a explorer and even was ready to have it cut so I could use two short side axles and it should have measured...
Preston, You can find these codes on the tag bolted to the pumpkin. Or go back to MustangII. net and click on door codes and then just open the...
Jerilyn & Countrymav, try this link, http://mustangii.net/ there is a lot of good info there in the tech center, click on rear axle codes...
No guesses on your valvetrain issue but if you need encouragement to do a "how-to" on your T-5 install I would really like to see that.
You didn't say whether you had an aftermarket cam installed. If you do it may have too much lift for stock springs if that's what's been...
Thanks old Guy, I am familiar with that site. I twice bought bellhousings from the company that maintains the site. I had a converter without a...
Separate names with a comma.
