A few questions I hope you all can clarify and help with. I pulled the old, dead tired 170 from the Mav yesterday. When I pulled it, we (my son...
Thanks to all who replied, as it was a faulty switch. My son changed it out himself in about 10 minutes, and installed a car alarm in about 15....
Its weird, as my son actually caught up with the guy, who took a swing at him, so he proceded to put him down and use the old Ultimate Fighting...
This problem just started with my son's 77. Someone broke into his car and stole his cell phone, some cds yesterday, and now with all the power...
Boy fellas, do I feel like an idiot. I went back through the ol Ford factory manual and was doing some reading, and just out of curiosity, I did...
What's the best way to remove an old choke heater tube from the mainfold below the carb (rusted through on my 70, 170) and where is the best place...
:angry: I'm really close to selling this POS as now this is the 4th carb, still won't run right. Changed the points/condenser to pertronix, still...
:hmmm: On my son's 77, it has some leaks somewhere that I can't seem to find. The carpet in the front and back is wet almost continiuosly (it...
2 Mavs here, 70/77 2 Door. New total: 573 JLB
Any certain adhesive I should use to install the rather spendy weatherstripping? Thanks JLB
I was wondering, in everyone's opinion, what would be the best year 302 for a swap in a 70 Mav? I have found them ranging from 1966 to 1993. Just...
I called Holley and they said it sounds like a problem in the carb, so I'll take it back and try one more time.
The tranny is a C4S, which is foriegn to me at this point. Shifting w/o a clutch, reminds me of a Honda 90 I had once. But like I said before,...
The holley reman carb is "stripped" in comparison to the Carter that it replaced. There is no adjustment screws for the choke on the opposite...
I've been doing some research and I think this (pertronix) is the way that I will go, but I'm unclear if the coil needs to be replaced also, or...
I want to change the distributor on my 70 MAV (170 I6) from points to some type of electronic system. What is the easiest route and how...
Ok here goes. I can get it to start and idle, but at very high RPM. When I try to adjust it to the proper RPMs for the curb idle, it dies when...
I finally got a replacement carb (Holley reman carter yf) for the 70 Mav and I'm having problems getting it to idle right. Can someone give me...
I finally got it home and have began to monkey around with it a bit. I have a couple of questions that I hope some of you could shed some light...
Here are some of the pics. Interior is amazing with the exception of a tear in the bench. One small ding on the back truck lid which should be an...
Separate names with a comma.
