I owned both a 1976 360 and a 390 F150 and F250 super cab trucks. The 360 was not a performer at all. A very poor setup. The 390 was a factory...
When you fit them, the front rubbers should not be against the springs but an inch or below. This make them slap harder and work better in...
There is a lot of science involved in an exhaust system application for each engine. It is never a matter of bigger is better. The reasons are...
Thanks Dan. A little on the rich side.
If you have floor shift, the Heddmon shorties would be the a better choice at about $110 over stock irons.
Anyone know of an air spring conversion to fit stock front suspension?
Another interesting setup is my Kenne Bell super charger operation on my 90 Lincoln speed density. It has it's own special requirements and gets...
Yes thats right if the sensors don't get up to a temp. of 600*+ they won't work and the computer falls back on fixed fuel tables, asumming there...
You are correct on ox sensors ability to (follow the fire order) which is always after combustion takes place in any cylinder that the sensor see...
Four items. The speed density and mass air still use the same tables. A speed density computer plugged into a mass air car will still allow the...
The 89 should be a roller cam motor. The truck intake while bolting up to the 89 ok, will be to high to fit the Mav unless you put some kind of...
If your going to retrofit a 302 motor, you need to rewire the computer to injectors to the 302 fire order, settle on a distributer configuration...
I have never saw the car with the hood off. It has very large drag slick on with a narrow rear. Not a street car. Did see a early Mustang with...
Saw a car this last sunday with a 429 in it. The car has be drag racing for a number of years and is now for sale. Sign said $4000. Location is...
Here is the website to find all the common wiring for MSD boxes. There is a link for the Dura spark dist. listed part way down the page....
Something I have seen happen is the hose develpes a leak from the inside out to between the inner and outer layer of the hose. The rubber covering...
For the record here, I am not defending what setup is used except to say that if an engine is taken down more often than a street only version,...
Guys if I just said that, a lot of people would be offended but yes there is pros and cons involving rod to stroke ratios. This gets into piston...
Going 347 stroker leaves off a lot of problems that putting a 351 in would generate besides the extra weight of the 351 motor. 4cu inches...
Forgot to comment that these items are why one cannot just take a carb out of the box, bolt it on and go without problems much of the time because...
Separate names with a comma.
