Ok if the numbers I have are right the length is 73 inches, the molding for 68 mustang measures 77.5-78 inches.
I would be thankful if someone has the time to measure front fender to the back fender running under the door.(2 door maverick) There has been a...
Has to be a full leak somewhere, 75 miles to a tank!((about 5 miles a gallon) I find it hard to believe the engine could run to burn that much...
There is no vacuum motor just vacuum off the engine which feeds to the vacuum canister. From the vacuum canister the vacuum line heads to the...
where can I get running boards like these.(lower molding running from front to back with the exhaust dump)...
carbs would be the right size if you were running 408 stroked 351w. (Way overkill on the 302.) Btw the vapor is blow by (its normal to see vapor...
I'm curious to see if the 302 6901 headers will hit the newer style power steering pump. Heres the link for the variable assist...
on my power steering I'm toying with the idea of using the thunderbird sc power steering controller. In theory when I apply 550mvs to the...
yes the 8" is also offset to the passenger side about 2.5 inches. When install the yoke lines up with tunnel. I can take a picture and show you...
yea cost was about 450, included narrowing (I supplied the axle and its only one side thats getting narrowed) grinding off all the brackets,...
when the power steering is fresh and dialed in the system works fine. Considering most systems are worn out people rather switch to something else...
Your lucky the belt doesn't slip on the water pump under high load. I thought the rule of thumb was to have at least half the rotating body...
get rid of the holley 750 dp and go with a proform 650 dp or even vaccuum secondary. You'll pick up at least 20hps if your using a standard...
What is the best tool for removing the window trim around doors? I'm sure its something that Harbor Freight has in stock. thanks nm made my...
I read before that if you install the 96+ explorer rear offcenter that the driveline will hit the tranmission tunnel. How much clearance will I...
same boat You have to use the stock computer from the explorer. No cost short cuts here! The ecu controls both the engine and tranny, cost for a...
nope When doing the disc swap the axles stay where they are. The rim will have the same location as before. Best bang for the buck, grab an...
I plan to finish the swap soon on my maverick. I'm running 05 mustang rims so the offset is fine for the 8.8 , I may need to clearance for the...
vapor lock? If you can start the car 2 hours later with it running fine it might be vapor lock. Incorrect timing plus bad carb tuning can get...
evo sensor Toying with the idea of installing EVO control solenoid from a thunderbird, and wiring in a switch for 0ma, 225ma, 550ma. Here's...
Separate names with a comma.
