ok well what about the issue of the tire turning while in park? rearend gears possibly toast? Also where would I find an axle? Auto parts store...
72 maverick auto trans if it matters. Got cut off in slick weather spun around smashed the rear passenger rim up...and i guess the axle too....
dont have a tack on it. I want to get one for it though where/how would i connect it? Also got a new fuel filter no change.
try pulling it up as in raise the timing? I can start the car and i have to give it some gas for a good 10-30 seconds to get it to idle by...
what an E.W.A.G? and how would I set the timing then?
Still having issues with the Mav dying at idle unless I put it into neutral causing it to idle higher so that it doesnt. Car runs fine just not at...
ok so quick question before i do this. Havent had time til now. I have non adjustable rockers. So do i just tighten each of the bolts to the 34-36...
I believe its a bad diode in the alternator. Only one wire with the car off sparks as i mentioned above.
never mind found this diagram of my carb. top one is for clean air/choke? bottom is for vacuum/distributor
whats the difference between the last two diagrams? I see the difference but what is the difference in the running of the car? Also im not sure...
yes thats it! ospho. Thanks! Does anyone know how to use just phosphoric acid and the difference between the two?
not for my year. Mine doesnt have the amplifier or reservoir. It does answer the positioning for my egr valve on the distributor and such. Now I...
Ok thanks. Dont remember how I had set them since its been a while. Might as well go back and do them again just to be sure. Still havent gotten...
200 i6 1972 year. I think the carb is original. I have a line from the distributor (the one closer to the cap) going to the top pts valve port,...
ok. Well I guess my main question is still unanswered. What do I treat the metal with before painting to prevent rust? acid wise that is. Also I...
when it says to turn the crankshaft 1/3 turn for each valve does that mean do cylinder 1 just first valve closest to the front of the car. turn...
which one is the alt power cable? I remember when the problem first started the bottom push on wire that goes to the voltage regulator i believe...
Ok so ive been told in the past after wire wheeling away rust before primering i should treat the bare metal with some type of acid I can get at...
72 mav I6 200. cant remember how I set the rockers after removing the head. Just want to double check them. Ive set rockers before but wasnt sure...
Ah didnt think to just pull fuses til the voltage stops dropping. Ill do that.
Separate names with a comma.
