Do I need a 1.5 or 3 ohm coil? How do they differ
Okie dokie. ill set up the line then. Thanks! And ill be sure to contact ya if I have further questions.
What part number is yours? Its hard to figure out what EI I need from pertronix. I think I need #1261 but not sure on that.
I guess my question was if i dont intend to use the choke setup and I dont have the line from the manifold, does it affect my carb/engine
ok well i figured i may replace my coil too. I think i can get a EI and Coil for $130 give or take. If I wanted to change my distributor what...
72 I6 200. Looking to get an EI to replace my points so I dont have to worry about points and gapping, etc. My question is what all will I need?...
Ok. Does it affect it if there is no line hooked up for the choke for hot air?
Ah i see. where does the other end of the choke line that threads into the carb go? i have it but not sure where it goes.
Ok so carter yf carb. When installing the blakc choke cover thing on the top/side of the carb you turn it in order to set it then tighten the 3...
okie dokie will do! And i always use new plugs when figuring mixtures. Do a lot of work on carb'd bikes so i know all about that.
cool thanks! If im using on a 200 think ill have to change any of that or maybe just tune the mix screw a bit different?
I have a carter 4916s yf carb. In order for me to set the float and such i have to know the year/make/model of the cars that used it. Itd be for...
Well i got my 72 running but with lots of rust for $730. Sooo compared to that id give up $200 more to have no rust and "it was running"
No the header on a i6 goes into TWO pipes 3 cylinders to each. no turn out or downs, just the glass packs open ends. Ill have to put some more...
72 I6 200 engine. header, to cross over pipe at the end and two glass packs connected directly to the cross over, they end right behind the bench...
Id pay $1500 for it.
should of. Maybe ill pass on the fenders and just do a hood. Thatll keep me busy long enough.
ive done fg once back in HS. Made a custom center console. Used foam and shaped it. Lots of sanding I know but it came out pretty great.
hmm well I suppose ill start with a hood and if it turns out good ill make a few more and sell em on here or ebay. Im sure some of you guys would...
Why ya gotta ruin my fun? haha. Just thought itd be a cool project. Suppose Ill start with making a fiberglass hood.
Separate names with a comma.
