yea thatd be great. I was told the carb I have isnt the correct one for my year? Unless the engine isnt a 72. Which Im not sure of since I...
ok i have a port on the base of the carb thats blocked off. not sure if its supposed to go any where? and does the outer port of the distributor...
carb is on. i have the trans connected to the manifold, outer diaphram on distributor to the carb inner port on the distributor not hooked up...
here are links to different vacuum connections. not sure what iam supposed to use. http://1bad6t.com/Maverick/repair/emission_controls_02.html#a...
72 maverick, not sure on engine year not sure where to find the vin on it. Its an i6 200. I see C8DE and B015 B under that on the exhaust side of...
okie dokie thanks!
ok one last question. Is cylinder 1 at the front or back?
umm so should i do the turning and sequence stuff then?
ok thanks! Im glad i dont have to do all of that stuff. Less work for me! For the steps for tightening im guessing thats do the sequence...
Ok just to make sure I have the rocker tightening sequence correct. - I make a mark/line at the tdc mark when it reaches the "pointer". - Make...
Hey everyone had to remove the head on my i6 200. Had some exhaust bolts break off in it and had to have them machined out. Will be picking the...
Gotcha, just order one from autozone! Thanks guys!
I had to remove the head on my i6 200 to have the manifold bolts machined out. So now Im looking for a place to but the head gasket and valve...
ok so i welded a nut to the longest stud and when i tried to remove the stud the nut just twisted off with some of the stud in it. too much heat?...
71gold- I would think a new head and the work done on it would cost more than having the bolts removed by the machinist.
well craig as good of a deal as that sounds i dont want to do all the work of a transplant. Although next spring the engine is coming out and the...
well auto shop said $160 machine shop is $25 a stud. 7 studs so $175. Going to weld some nuts to those sticking out and see if i cant get them...
Id like to have the head gone through and new guides.seals, etc but I dont have the money to pay someone to do it. If its an easy task feel free...
As I mentioned above because of the angle I will not be able to get a drill in the engine bay to properly remove the studs. I have manifold off...
Some of the bolts are flush- 3 i believe and 3 or 4 are sticking out. The way the bolts are angled downward look like Ill have to remove the...
Separate names with a comma.
