like a brazing torch? or a hand held mapp gas style? how does heating them help? Any ideas on cost for having the studs removed and/or holes...
72 maverick I6 200. Was removing the bolts for the manifold to put a header on and all but 2 or 3 bolts snapped off. They are rust and probably...
ok just a few other questions for prep then. The naval jelly directions say to apply and leave on for 15min. longer if rust is bad and then rinse...
gotcha thanks! What about the rust remover naval jelly stuff from napa? is that the same as the phosphoric acid mentioned above?
Ok so I have been repairing the driver side fender and there are numerous smaller rust holes. I am having a hard time filling them with out...
the headers i picked up for 225- it costs like $25 more i think? if you want them powder coated or chromed or whatever. and shipping was like $26....
its not too bad most of the but it does make for an interesting challenge at times. wish I had a table to weld on...
well here are pics of my progress this weekend. not done patching but getting close. doesnt look the best either. oh well. we shall see how it...
Started work on the driver fender. Got it off of the car and cut and patched some of the rust. started filling in pin holes and cleaning up the...
Yep i can weld. Started trying to fill some pin holes yesterday on the fender. Its a bit of work to do it. since its thin where the rust is but...
Just wanted to add my experiences with comments. My mav is far from looking good but it drives and Ive always had compliments on it even the way...
well when ive been wire wheeling it goes from the blue on it to bondo or metal. did they use a grey primer of sorts out of the factory? paint...
Separate names with a comma.
