thanks, I am install a bushing in the end of the column
that clears it up for me, since I went to a mustang rack with universal joints I will have to add a support bearing because of this.
true, does the rag joint flange come off the column shaft with a puller? That would make this easier.
Got the Granada rear in, just to work out a few small issues now.
Is there a bearing in the steering column near the fire wall I can replace? I can move the shaft where it just enters the engine bay a half inch...
yes, the stock hood will close. I had to run the edelbrock elbow over the belt sander a few times after cutting the tab off and then rotate the...
It has been a while, but I am now complete with the engine compartment. The small things always take the longest amount of time. I think I have...
I was able to get the grill, filler panel and front bumper positioned to pretty much hide the intercooler, although it does hang below the bumper...
I am nearly complete with the fuel system, sump on stock tank, AEM 380, 10/100 micron filters, Aeromotive reg all installed. I am not overly...
[ATTACH] I was able to get a few more items off my list, fabricated the throttle and kick-down to function with the tb rotated for hood...
I find the AJE products a great value for the cost. There is a little weld splatter and no its maybe not perfection, but great weld penetration...
It's looking like the on3 cold side will work out after trimming a couple pieces. I will be making my own hotside as the on3 hotside places the...
I suspect the turbo upgrade will free up some hp as the 76/65 I had on prior was struggling starting at 5500 rpm and that's where I was shifting...
I had this set up in my previous car, except prior I was using the on3 headers and making 480rwhp on 10psi with a small on3 76/65 turbo. I will...
I made a little more progress and successfully can close the hood now. I cleaned up the top flange on my Edelbrock low profile elbow and installed...
I got my transmission cooler installed while waiting for parts.[ATTACH]
This intake set up is costing more than I was planning for. I had to cut costs and install a stock set of 5.8 f150 exhaust manifolds I have, just...
Very nice, looks like you have access to a milling machine. I will test fit the ultra low intake elbow I ordered up and see as I may require some...
Great sleeper you have there, impressive times. My goal to keep the hood stock and flat and here is a pic of my second failed attempt. I have...
The deciding factor for me on which kit to utilize was preference, cost, and availability. I prefer the mustang fox style suspension and I have...
Separate names with a comma.
