I still have the trooper box I mentioned in earlier post...And if you add an electric power assist to column I don't think you will get any...
I did some homework and in 2011 I figured that box that is used by Borgension to retro into the Mav/Com [and other applications] is the 2001 Isusu...
Up date to clutch linkage, made new arm off of equiliser link for less movement at arm.. Adjusted to maintian some throw out brg clearence which...
Here is the first build above stock: 200 cube, factory rotating assy.. Clifford HD timing chain, Isky 280° cam [.440 lift] and Springs, Retainers,...
Made a replacement gear retaining clip and put trans back together and in car..Z bar and linkage all in and adjusted at lower ratio and makes for...
I took the trans out today, and got the tailhousing off..Found the speedo gear clip hidding in a little nook in the rear of the main case..Whew,...
Today I made an adition to the Z bar lower arm, adding another peice to the forward edge with a bunch of holes to try different ratios..While...
Here is where I'm at so far: I figured a way to remove the under dash clutch helper spring with out hurting myself and it made a good difference...
No pivot ball in my system, old style with z-bar..When I put the linkage back in everything was fine even free play was ok but the 1" of sharp...
After many calls I settled on a clutch from RAM through Must Unlimited..Diafram and to my surprise a metalic six puck disc, MU garentees it for...
You must get all the hardware from a manual shift car, most likely with [or had] a 200 6cyl, clutch an brake pedals, brackets, clutch linkage,...
Well I got it in...Shifter area of the T5 would not clear the hump behind the crossmember as well as the shifter tube hitting the crossmember and...
I guess I must, I'll have to cry a little first [car only has 15k miles] and then get to it..Sigh....
Ok, I didn't think there was going to be a magic solution, :cry:..Just trimming up the brace to the floor is enough or does some of the floor...
Well I got the T5z in but to my surprise :confused: I can't get it high enough as the shifter tube hits the tunnel brace, even the main top cover...
In my Comet I have built the six up some, lotta head work, cam [290], 2v carb, Header & big exhaust..Since I have the trans and Bell out for a...
I am getting the .80 from 5speeds.com...I got the Counter gear support from them and is really nice peice..
Somewheres I had info on either a Power Steering Box or Rack conversion..Be damned if I can find it now, searched best I can..I want to get faster...
I ordered trans and adaptor from CJP last friday at 4:30 pm and all was here Wednesday..I was impressed! 5th gears of 53/33 for a .80 [probably...
Yes, you guys are right, actual OD ratio depends on 1st gear ratio...One place I looked [Astrogear] tells that the 5th gear set of 55t/31t will...
Separate names with a comma.
