Thanks BMcdaniel. Did you need to lift the engine on the drivers side to get them in, and how is ground clearance? Any other issues ....was any...
Thanks , appreciate fast reply . I am manual steering and manual trans (t-5 but it uses the 71 maverick factory clutch lever bracket since the...
71 302 with a T-5. Lots of different versions of what works. Prefer shorties or try Y but ultimately will go with whatever works with this...
Installed LED light bulbs in front blinkers and back brake lights. At same time replaced rusty socket. Lots of issues after such as no side...
Running 215 60's.......as you indicate....might need to have some more rubber meeting the road than that...or traction bars. On my previous...
Thanks everyone for rapid and clear advice. I am going with the 3.55's as overall that seems to be the best fit. I do drive the car frequently...
Stock 302 block/heads, mild cam, 650cfm vacuum secondaries. Never had it dyno'd. 1st gear ratio is 3.35....lots of folks saying 3.8 way to steep...
71 Grabber with a 1986 WC T5. Just ordered 3.80 Trac Loc and I have now heard that 3.80 is way to steep and 1st gear will be useless among other...
Eric. Thanks again for your help and extremely useful photos. I am back in action! Ended up bailing on my old turn signal switch (that I put the...
Thats the part (cam spring), thanks. I am back together but no blinkers (checked fuse too). I started with working blinkers but a broken blinker...
while removing my turn signal switch from the column (floor shift column) and the turn signal cam from the switch a thin piece of metal fell out...
My 71 302 non a/c Grabber has one of those aluminum flex fans on it (prior owner) and it makes alot of noise at mid to high rpm. I want to replace...
Hi all, I've been off the forums for a while, but now that musclecar season is in full swing, I'm here again:thumbs2: Hope everyone's winter...
Thanks. So are you saying I do need 12 volts and the solution is to find a wire that is hot when the key is on (and off when key is off).
Bought a 72 w/302, converted to pertronix electronic ignition before I bought it. How do I check to assure the coil is getting the proper...
Coil Voltage - Checking & Issue resolution Bought a 72 w/302, converted to pertronix electronic ignition. How do I check to assure the coil is...
First car was a 1971 Grabber. Dad was a manager at a Ford dealer and got it new and gave it to my Mom. I picked it up as my first car in 1979....
Ok....all set now. Thanks to some help from my fellow forum members and from a local Ford Dealer. 1. The Caliper is held into its cradle by...
Thanks for prompt reply. Wheels are not hitting calipers and the pads are tight when the wheel is off. yet, when I drive the rattle like...
Separate names with a comma.
