what you see is what i got. 74 grabber 6cyl. per the vin
check your pcv valve and make sure it is not sticking too. If the engine is building pressure in the crank case it will push oil round your rings...
What is the problem with left turns. I just got a 74 that i was planning to put these headers on with a floor shifter and no p/s.
Found a fair 74 2dr to make into my daily driver. No engine or trans, and it has taken on some dope in the usual places, but I didn't think it...
OVERSPRAY OVERSPRAY OVERSPRAY!!!!!!! It will be on anything you don't mask up. I would recommend masking the entire car to keep the over spray...
with the size cam and low comp pistions i am using there have been no issues in setup at all. It pretty much bolts together as is.
Here is what I have on the table as of now. 351w block, balanced steel 10:1 rotating assembly from ohio crankshaft 408 cid, Jegs/Kaase...
Dave, that was great. Thank you so much for that idea. That is all i wanted from my post. Some ideas. Any of you guys ever heard a hard head...
Wonderful, I have an idea on what a "serious engine" is now. I think mine will fall in this category, so........ any suggestions/info/help on...
What's considered a serious engine around here?
I ordered a set of 6208's for our Mav 351w. I have not installed the engine or used the headers and i am thinking of sending them back if i can...
How many of you guys are running these converters? What are your opinions on their quality? I currently run a Fairbanks 3500, and wanting to...
misc photos kDS and CPD
I second that. Best I have ever used.
thanks again for all the suggestions. The throttle stop is the way we will go.
thanks for all of the imput guys. as far as the timing goes, can it be retarted too much?
how and how much can a engine be safely detuned? Scenario: a well build 427 engine in a well built chassis car. not so well of a driver. how...
several mods will have to be made due to the front end already on the car. The guy who built the car has replaced the front end with what looks...
Separate names with a comma.
