Probably no different, but by the end of the 60s the big three were showing a certain squeamishness toward high HP machines IMO. Why put a tab...
I guess the mechanic with hands as thin as paper hasnt been found yet to change plugs either.....:lolup:
If one does not cut the shock towers, how well does a boss fit? It would be curious to see the list of mods on that prototype. I would guess the...
3K is good offer. If it must go, that seems to be a good answer. Most of us hope our cars will go up in value, but I dont think a single one of...
I had rust in my trunk floor. I coated the floor with POR 15 and laid fiberglass matt in it, more POR 15 and a layer of fiberglass cloth, followed...
LOL.....Santa left me enough to get some lowering blocks if it ever warms up enough to crawl under there.
Welcome from Portland OR. Very cool trailer....and good luck on your new '67.
My heater blower motor has a ground to the engine side of the firewall. I would re work that ground and see if your heater motors starts again....
Once that is running, let us know what your thoughts are.
What did you replace with that, and did you notice better MPG? Did you have to fiddle with it or just install and adjust idle mixture? The...
I have a tune up book that is 400 pages long and will probably have little to do with making a car much faster....sometimes my brain needs the...
Ahem.......I dont have the experience to get the last 2% out of my set-up, but my distributor is re-curved and the points got tossed for some...
Is your car a daily driver? I dont have a garage either....but since my car is just a toy, I dont work on it when it is cold or wet....because I...
Welcome from Portland, OR. I had an old chevy van that started smoking with 105K miles on it. It ran good and had decent compression so I figured...
The float was missing from my sending unit. When I took it out and tried to clean it up, the wires fell off. I resoldered them and re-used my old...
That is a wonderful car....an I am sure it cost more than 40K just in parts. Someone liked the color and got a good deal.
I used the autozone version too. Looks the same, and I was very cautious with it but it worked fine. Make sure the arms are on the spring...
I am using a Holley 0-80456SA with the electric choke and choke plate removed. I dont drive it in the Winter, but it starts easily when I give it...
My block ID #s tell me I have a 71 torino block. I got compression test #s from 150-165 when I first checked it. Two years later I checked it and...
I used a throttle cable and mount from a v8 Granada. I had to mess with the manifold mount a little bit. I have a "torker 289" manifold with a...
Separate names with a comma.
