go into the block pistons heads all that good stuff.
I have used both on thin stuff just rev pol and the heat is on the rod not the metal good to go keep it going. the argon is to put a sealer on the...
I just want a bumper on mine for the moment
where did you get your panels from? looks nice
if i am not mistaken they came with two diffrent tank sizes what do you need.
new sometimes is better than the old not often but sometimes.
super charge it you can never have tomuch
check the heater coil
looks better than mine man nice job.
might be a dead ground in somthing look at the whole cars wiring for shaved marks.
a junk yard could get you some better than that.
we just put in a hard switch or a t valve on the rear line it is under the dash it was easy and when you turned it it was off no problem. the...
smooth is my vote the one i worked on was rough and it is hard on anything that slides on it or comes in contact with it.
all you need is wire that is just about half the size of your battery cable if that. just to keep the voltage flowing. nothing to worry about.
this cars radio should have a central ground on it most did. the new radios dont thay only ground through the radio. you can try.
vaseline on the bottem side works. but you can go mud flaps, curb feelers, and some big hundred spokes with chopers. your call.
hot glue and a hammer sounds good to me.
sounds like a head gasket and a stat. prob drain and change kinda deal. just did it to mine not the head gasket just the stat. will take about an...
i hope that my replacement goes as prity as that one dose.
Im in the process of finding a grabber hood. I was wondering if any one knew what it would take to make it a working hood that air can flow through.
Separate names with a comma.
