I just pulled my z-bar linkage out from my auto/column shift, do you need one, or trying to make one?
I got it, thanks guys. I had to remove the entire assembly for windshield removal. Thanks!
ok, Im sure this is a dumb question with an easy answer, lol but how do you remove the wiper arms from the actuator? I tried pulliing in the clip...
I have a chance at getting a 9" for really cheap, but it's out of a 1969 Ford P/U (narrow axle guy says) is it worth it? And what would I have...
Good 'ol OK ice storms!
we had heavy ice storms a few weeks ago, and I noticed rain entering from the top of the winshield. I sealed it up temporarily with RTV. Pulled...
thanks, got everything out now, including the carpet......entire floor pan is rusted, drivers side is through......:cry:
HELP!!!! PLEASE!!!! :( I've spent the past 2 hours trying to figure out how to get my front bench seat out. I removed the split backs, hoping...
that might be safer, after removing the knob, I didnt touch the shaft. Just unscrewed the whole thing from the front and pushed it through.
the wiring harness is long enough to allow play. If you remove the nut holding it to the dash, you can push it through to the inside and let it...
Hi guys, I just wanted to comment on Mavrick Newb's idea about LED's. They are a great light source that use much less amps and tend to be...
the nut holding the switch to the dash is on the front (silver ring) using a flathead, or coin....etc. loosen that and remove. Your switch should...
Had an idea the other day, has anyone here done a rear seat delete? I was thinking like the old Shelby's did, where the trunk and rear made a...
just went to the email, and it's been turned of/deleted by yahoo :( Does anyone still have the blueprints for these?
The dash gauges are 3-3/4" This is one of the standard sizes with most aftermarket gauges. Mounting them and wiring might be interesting though.
I thought all of the horizontal lines of the Mav were accented further, keeping with the new hype of "retro" cars.
ok, found this on youtube, had to share! [media]
thanks!!! I'm pricing out the sheet stuff tonight. I always do my own work (until I destroy it) lol. How do you get the contours/curvature for them?
Separate names with a comma.
