Don't you need to bolt down the bell housing first then the converter? Iv always seated the converter all the way into the trans. then lifted...
I did some cleaning on the floor pans. not as bad as i first thought.
how close is the floor pan from a 1970 maverick too that of a 1973 maverick? I know the trans tunnel is smaller on the 70. but what about the...
Didn't HP 289 have screw in rocker studs? I would try to bleed down a lifter. If they will not bleed down they maybe solid lifters. If they are...
Thats the plan. I'm working on getting the floor pans and torque box that I need. I am going to hold off on pulling the windshield till the torque...
where abouts in Michigan are you located?
I had a 1970 maverick that had cracks in the rear frame rails, right at the top of arch. Somebody before me had a trailer hitch welded to the...
What would you fix first. (the car will go on a rotisserie)
The driver side toe board and driver side torque box are shot, and need to be replaced. The car has a bad cowl.
more photos This weekend I will try to pull the front and back glass, and the dash. Then maybe start on the front clip and engine/trans.
I started the tear down of my 1973 yellow Dearborn maverick. I got the interior out Friday. Passenger side front looks good from the inside,...
shifter out of adjustment, could cause the detents and interlock pin to hang and cause hard shifting. if the 3-4 shift rod is not completely...
how you get a 3/16 stud in a 2/16 (1/8) hole?:hmmm:
David Kee toploaders has a custom made one that is bolt on for $380 with master cylinder
V8 manual shift linkage
I have been working lots of hours and didn't have much time to mess with the car. I ordered the report 6 to 8 weeks ago. Now that I'm off work for...
1973 model year. manufactured in Dearborn. 2 door sedan. 302 v8 engine. produced on 05/09/1973, with the following options; medium yellow...
try http://www.rightstuffdetailing.com/2004_pdf/mustang.pdf look on page 6 maverick/comet are on the bottom of page 6
put a volt meter on the battery and see how far it drops when cranking.
Post a pic of the side of your trans. Need to know the location of the shifter mounting on the tail shaft.
Separate names with a comma.
