I bought a summit carb, 600 cfm, stock 96 roller motor, and it couldn't handle anymore than that, at least to be a good driver. I would have...
What other types of cars are you competing with? How does your maverick measure up? (against newer cars for example)
I put some dielectric grease in the bulb socket and on the harness plugs; stop the corrosion
I had it aligned at a nearby garage, older guys that work on old and new cars. The center caps come with these magnums, there is a black sticker...
Got mine fixed. The grill was replaced at some point, and whoever pulled this one from another car, just snipped the wire off. Then, they had...
Mine's doing the exact same thing. Look forward to hearing what you find.
Larry, the print out said it was well within the Shelby spec. They told me they could go with factory spec and it wouldn't touch, but I wanted...
I had the alignment done yesterday to the Shelby specs. New tie rod ends too. The car handles great now, then I put on the new kyb rear shocks,...
Cj pony says 4 inch. Would a spacer give a bit more clearance?
Well, I changed the suspension back to factory with new shocks and it's not hitting now. I can't be bothered messing with it (drop), I want to...
OK, thanks everyone, I'll try what Bryant said and let you know how it goes in a week or so.
Cool. What type of shim? Tapered or just machine washers? And how thick (shims, spacing) do you recommend? 1/8 of an inch?
That makes sense. I researched it all first and I was sure it had to be down an inch from the plane of the original holes 90 degrees, not an inch...
I dropped the hole 1 inch down, not rearward at all like the 65-66 mustang requires. The tire is not as close to the rear of the well. As far as...
Just have to try an alignment, but I'm not sure if the lower control arm can be pushed back with the strut rod to give a bit more clearance....
Raised it up to an inch and a half with jack and it still hits.
[ATTACH] [ATTACH] Different crest.
A bit, but its probably dropped 3/8 inch with the mod. I'll try raising the front end 3/8 with my floor jack, then check the clearance.[ATTACH]
I don't think so. There are two different red ones. The crest is slightly different. A torino of the same time period should work for you.
You mean bolted tightly to the shock towers? Yes they are very tight.
Separate names with a comma.
