Okay well, I've been reading about shimming the springs and it doesnt seem like something i want to risk, because i really dont want the springs...
Oh okay. Should I get new stock springs then? If so, do I need a professional to replace them or is it possible to do it myself? I've never had to...
Okay, so then heres whats going down so far when i went to the machine shop earlier today. The engine is going to be bored .040 over after all and...
I just dont have the funds right now for performance heads. Later on, i was planning on trying the GT40 heads but as for now theres not much extra...
Okay. I'll ask them to mill the block. About .010 then should be good if the deck height is as you say it is? And okay. I'll drill those out of...
Okay, how much should I have them mill the heads? About .010? Or more? And I am planning on plugging the smog holes until I am able to buy new...
Okay, well took my engine to the shop today. Going to have it bored .030 over and undersized about .010. (Nick in the cylinder wall and very old...
I had actually been searching on summit for quite a long time and it seems I'll need to get it bored to find those pistons because the best I've...
That's actually what surprised me. There are no markings on the piston tops at all, so i figured it mustve been bored, but i guess not. It hasnt...
Hey everybody, I said I'd keep you guys updated so here goes: I've stripped the engine down to bare block and main bearings (Going to get it...
Okay. Thanks! At 70 mph my Speedometer reads 60, so im not sure what tooth number i have but ill go in increments one lower. :tiphat:
Hi All. Well, this problem has been plaguing me for some time now. But now that im restoring her i figured i would fix this. I purchased a...
Correct me if im wrong, but it seems like its modeled after a 1965 mustang throttle linkage assembly.. [IMG]
It's actually an electronic ignition (go figure..?) that was Original. But perhaps it's is the rebuild quality of it. I'll go try and exchange it....
That's actually what I was thinking as well.. When the old distributer was in it ran fine. Had a couple misses, stumbled a little at idle...
Okay. Well I'll try to get a TDC mark with some chalk today and see if I can't just fix the reference point because that would probably help a...
I put an A1 Cardone rebuilt in its place, but if I was one tooth off, would it allow me to advance it too far and retard it too far?
I've tried. That's another issue. I actually dont have a timing mark to base it off of. The Harmonic Balancer seems to be off because the 0* does...
Hey guys, I have a bit of an issue I've run into while trying to increase the efficiency of my car. Just to get you guys up to speed, I have a...
okay then, so i suppose the next purchase will be a brake switch then? I guess I'll see what i can do. And then what should i do to get the turn...
Separate names with a comma.
