Jump the battery to the ignition terminal on the starter solenoid with a jumper wire.
I dont think our mavs ever came with ammeters. This is more of a problem on old mopars. I will attempt to explain all the workings of ammeters...
Alright I checked, and I was wrong. Apperently, our mavs dont care which one you use, just pick one and go with it, theres no manifold or...
The evaporator only sees low side pressure, but there is a right way and wrong way to hook it up. I can check which one it is when I get home,...
Also check the clutch. I've had a few bad ones, just make sure its actually the belts slipping, not the clutch
My '75 ldo came with 4 leafs. It was a 250 c4 w/ac
If you have decided you must get the rubber out of them, use a torch.
Same thing, just different names. That page said they dont squeak like *polyurethane* bushings.
Totally depends on what year and model jeep. Can you give us more specifics on the rear end? Is it a dana 35c, 44, amc 20, ect? What kind of...
No, put the #1 teminal to a switched 12v source, its what turns the alternator on. The #2 terminal is the sense terminal. Some will tell you its...
Have you replaced the regulator also?
Bypassing it works, but like Mr. Selvey said above, its not hard to replace. It can be a little bit of a safety issue too, if you need the...
The big spline NP 833 is about as bulletproof as a toploader, but it was mostly a mopar tranny, I think some chebby 4x4 trucks got it too.
When an engine gets alot of miles on it, combustion pressure starts leaking past the rings into the crankcase. Its called blowby, and thats most...
Nah, try a thermo-quad. Those things can be a big pita
If you have the room, puller is the way to go:2thumbs:
nope. the 200 is a couple inches longer
My '75 had a box in the same spot, i thought it was a starter interlock, but i didn't think any '75s had one after congress outlawed them? Build...
Like DaMadman said, go with a carb. If you want to go EFI, you need to find a complete efi harness, manifold, ecu, the whole works, and pull it...
Computer? I'm guessing you pulled an EFI from whatever you got that 5.0 from? As far as a wiring harness, Painless Performance makes good...
Separate names with a comma.
