The lag could be caused by either a bad timing or no good accelerater pump, when it lags does it back fire, or does it just almost wana die or...
The one i was looking at had a search menu but a book also has an index.
There should not be any problems i had a 76 2bbl on my 73 and had no problems
I was looking at shop manuals and i found a few places that sell these shop manual CD-ROMS there about the same price as the normal book but...
Did any one else find this, that the 2 bbl had higher of the line torque, then when i changed to the 600cfm holley and duel plane i had lower off...
I tried something today i had a friend push the car while it was running and in neutral and i put it into drive and the car went but it still did...
I did a frount disk swap, new rear drums, new calipers, new brake lines, new steering control valve, new fan belts, new coil, new distributer, new...
I tuned the timing by taking out spark plug number 1 and sticking a finger in the hole and cranking the engine over.. other then that i didnt do...
Yes it does happen when i try to go into reverse, i dont think its a problem with the ignition because when i put it into drive it instantly jumps...
Do you have the drip railings over the doors or do 4 doors have those, my advice it to just go to a parts store and ask them for the seals if they...
Im haveing a problem with my comet and getting it into gear I try and put it into drive and it jumps forward and dies i just rebuilt the carb put...
Lose the vinyl.. hopefully the vinyl protected the roof some what.. I would say if theres no cancer holes get out the grinder and get at it.. if...
I dont think soo.. theres now down there is there?
Last night i got my new control valve put on and changed the oil i wanted to take it out for a spin see if i did a good job so i started it up...
ok thanks :bananaman hehe
What color should the power steering fluid be new... the stuff in my car was red but the stuff i bought was clear?
ok i got it out how do i bleed the control valve now
Would i be able to take a torch to the pitman arm to heat it up and make it expand or will that not work
would i be able to use the pitman arm puller to push the ball stud out of the pitman are... Just a thought... cuz if not i have to run out and...
LOL u called it i wrecked the valve and the joint is stuck in the pitman arm... how did u get it out ive trying to get it out with a pickle...
Separate names with a comma.
