honestly i was going to buy one...but i forgot to before i started all this lol, now im too close to being at the end.. i purchased one this...
haha ok..ill wear gloves and what not..open the bay door...and ill use paper towels to keep it wet and follow the directions from there..i think...
That's where I have my wires ran at the moment.. Right there on the pillar.. Mines a 5" though.. So fitment maybe an issue?
I have the doors back off the car and layed on a bench so that will make it easier to apply.. I will then wipe down with acetone and sand then...
The bolt connection through the firewall has to be tight.. Or else you will have nothing.. Give it a wiggle and see what happens.. Mine isn't...
There's a shelf full of rust converters and what not but no oshpo.. So should the I be looking for a phosphoric acid based treatment? Btw you have...
Yep.. But the chevelle needed a ton less work so I don't mind that much when I work on it I've looked for that ospho stuff and could never find...
Just bought some new doors and they have a lot of rock chips which has surface rust and won't sand out.. Does the spray can stuff that says it's...
Just measured mine.. It's 5" and has the shift light on it as well.. So it is quite large.
Where do you have it at? do you like it there or could there be a better spot? i have one of the large 5" or so autometer tach's..i had it over...
I'm excited to order one..
Got the new doors aligned quite well... Started to sand found a couple big issues.. Big crease with bondo... And a few rust holes.. Welded in 1...
to add what craig asked...what condition are the mags in?
glass shop here wanted 60 bucks for it lol. i laughed at him and walked away...i got a one from my parts car ;) get it new though if its under 30...
I had a cracked solder connection in my alternator ad it had troubles charging.. Soon as I tried to draw the extra amps through the lights would...
Looks like you bumped it! Long ago eh I may aswell keep going with it.. The wires were cut off mine and MIA so a couple months ago I welded...
i've used SEM a couple times now..will be using again on door panels/dash in the upcoiming weeks and i will be doing my chevelle dash/arm rests...
Seriously...? I seen you posted so i rushed to look and the first one I read Was back in stock again... From 07 lol... I got so excited till I...
what is the handling like with those shackles...?
i walked around it a bunch of times trying not to bump it with anything...was trying to clean up a bit taking tons of pics of extra stuff i have...
Separate names with a comma.
