Ooooh. Very interested in your blower setup. I know we've just met but, would it be considered too forward if I asked for a peek under her hood.
I have 17X9.5 with custom 4.25 bs and running 275's with trimmed fender wells. Looks great but... If I could do over again I'd do 18X9 same BS....
Oddly enough, the driveshaft did not have to be modified at all. Even the yoke from my c-4 slid right in and has about 1 inch of play. Thanks...
115.00 to shorten and balance? Does that sound fair?
t-5 and drive shaft length Question for those of your with a 302 - WC t-5 - 8" rear combo. What is the length of your drive shaft? I need to have...
Thanks for the input guys. I found a tailshaft for 75.00. Is this something I can easily replace myself or will I need special tools to do it. Are...
Is this unusable? It must have been damaged in shipping.
I used 66 mustang 620 springs designed to drop a mustang 1". I still ended up cutting a full coil to get it where I wanted it. My wheel wells are...
Are there any bolt-on replacements for callipers or is stock our only option. I'm not looking for anything that will require mods to mu existing...
How do I know when my Mav is running too hot. I have a 180* thermo. Normal running temp when going down the road is about 190*. Now that daily...
My dist never dropped right in even after turning the crank. I actually had to bang on the top of it to get it all the way in there. It was an...
I wont know if I'll be able to make it until the week of. I have to watch the weather pretty closely. The Mav's not quite waterproof yet.:bath:
This actually sounds do-able. My schedule is open and it is not toooo far away to make. Is there a place I can pitch a tent for the night?
Neither. I am talking about the plastic inner fender liner.
When I installed mine, I had to trim the splash gaurd pinch weld a little. I experienced some rubbing when turning a tight radius.
Hot Rod TV is on Spike now? What day and time?
DUDE your 5'2"? :biglaugh: Just kidding. Please dont squish me. :eek: Thanks everyone who voted for my car. I new it was a long shot with all...
I dont yet have a t-5. I am looking for one and it seems that those that need a rebuild are pretty cheap. Just wondering if it would be cost...
Anyone ever done this? How difficult is it? Are there any specialty tools required or will regular old hand tools be fine? Thanks
Its about time you update that site. I cant tell you the number of times I have looked over it for something new.
Separate names with a comma.
