Can I offer to tell that the output voltage above that needed to ignite the fuel mix is waisted. So going to a higher voltage coil would only...
You have Mustang supply companies in Canada. They can supply one. There pretty much all the same for the 302.
The outlets are at the wrong angle . Look at the headmon 88-400 shorties.
Hedmon #88-400 shorty headers will fit as long as the trans is an automatic and floor shift. The stock iron 302 manifolds will also fit.
Can't use the radiator. A/C will be custom work. Use the late compressor and hook to the original system. You may need a A/C shop to do this. It...
Need an electric fuel pump. There is no fuel pump mounting on the late blocks unless you are going fuel injection then you need a pickup truck FI...
They do now but back about two years there wasn't any in the smaller size.
My opinion is that 3" is way overkill on size. I don't think anyone makes a 2-1/4" H or X pipe is why I built my own. 3" is more costly and...
If you check the catalogs, the same long tube header number fits a lot of different Ford/Merc cars. From the header outlet back there is not much...
Normally in the run position, the red lead is open and only connected to the module so if you check it in that condition you can see voltage...
Yes. You will see it as a back feed. During starting, the module and coil gets full 12 volts. In run position there is a resistor in series with...
Hi Sara, I see you changed the dist. cap. Are you sure you got the wires back on so the fire order is not changed? That will make the engine...
Turning manifold around; The ports on the bottom won't match with the lower half. The truck port shapes are quite different.
Ok, the way for you to do this is use 5/16" grade 8 bolts of length needed for the assembly. Using at least 1/4" flat stock of the width/length...
There are after market type that are smaller and may get the clearence. The smaller upper manifold will loose lower end torque in favor of some...
Have you not looked at all the threads dealing with your question. Take a look please.
Sorry but you can't use a power booster with the right facing EFI upper plenm. New brace bars need to be made for both sides. I made them from...
That is quite right. Some lever effectivness is lost if the link is not lined up. I did this type of change on my Lincoln and built a pair of...
The clutch size is dictated by the size pressure plate your flywheel is drilled for. Most likey 10 ".
The motors with the 5L HO designation, 82 up, went to 50 oz balance and also needs the correct front damper. This applies to both man and auto...
Separate names with a comma.
