I don't think you can find any 1' or larger as a bolt on for these cars unless one is custom made or you get a bar and fab you own end levers. 1"...
I am running a c4 and a 73 motor rettrofitted to fuel injection. Others on this board are running the AOD behind both the EFI and carbed motors....
I reccomend that you use the Hedmon shorty headers and have the oxygen sensor mounts installed in the header pipes about 2 to 4 " from the header...
Fuel line can be found at Summit or Jeg's in 5/16"size rolls. The feed line must handle 100+ psi. The return is low pressure. Use of hi pressure...
Ok, need to plumb a new fuel feed and return lines to the tank and use a 85-87 pickup truck, external fuel pump. If the air intake is on the...
I neglected to mention that the AOD needs a special cable control that is operated by the carb. The cable control changes the internal trans pump...
You would need to measure the AOD from the bell housing back to the rear mount and compare it to a c4 for the difference. Then have an extension...
Yes you can remove the system and supply vacuum to a single advance distributer control from a ported vacuum source at the carb. The timing...
You can put the traction lock in your existing housing. They are a bolt in change. Should be checked for gear mesh, backlash and clutch disc...
Yepper. The trac lok houses the friction discs stackup and pressure spring assembly. They are about 5" in diameter. The open carrier has no...
There are several types of system controls that use this part to control the final action of the spark advance. They are all triggered into...
Got to thinking a little more about this. If I were you and know what I know about these things, I would go the other way and build a 289 to turn...
As Dave has shown, traction is a bigger problem than a small engine. I run a daily driver Lincoln Mark 7 with 3.27 Trac Lok rear , AOD trans in a...
To save yourself a gang of work and little problems, 302 stroker to 347 cu in would make near 375 hp + without to much effort and end up being...
If it is an 8" rear, any ford 8" center section or traction loc carrier will fit for you.
I was one of the last to post on the board a day or so before it was taken down. That board is often the scene of arguments often started by...
The traction lok discs are the same as used in the bigger 9" so they are easy to get. The spec for testing the lockup is 40 foot pounds but you...
The gears and posi are getting hard to locate at a low price. At a website www.perogie.com. you can see the 9 ratios they offer along with...
The stock one you have. The AOD needs an extension plate to the rear because it's mounting location is farther back about 4 " or so..
Tom, I have found that Mag in error more than once over the years. Just because it is a big Mag doesnot mean there writings are always accurate....
Separate names with a comma.
