The points, all have mentioned, is what my answers have been all along, to posts about FI conversion. It needs to be a genuine challange to do it...
Buy new ones and take the joints apart and replace them. Most Mustang suppliers have them.
If I ever have spare money, I would put a Kenny Bell blower on my EFI comet.( Full) boost at 2000 rpm at what ever boost level it is pullied for....
The float should not have any gas in it. I would replace the line up to the fuel pump as well. Alum. line is found at the speed shops or you can...
I had no luck using additive and lost the valve seats/valves in less than 8k miles on a new valve job and porting. Had seats put in. End of problems.
Before you put the sender back in, plug it up and swing the arm while some one watches the gauge to see is it was the problem. I can give you...
Sorry we gave a tonge lashing of sorts. Stay with it, were not that bad! We could have reccomended you ride a horse into battle like they did...
I'm not trying to insult you, but if you continue to run any car after loss of coolant there can be damage in many areas. The transmission oil...
I'm sure you did, but the cam and lifters must be coated with the special lube at assembly, and when started, the engine should be run at 2000+...
Ward, nice to here you got the project well under control. It is difficult to help long distance as you know. I am a moderator on one Lincoln...
The only difference between the dists are the pick up for the electronic module. The vacuum part works the same by pulling the plate around in...
Yes, the left rear of the intake will interfer. They can be made from 1" sq. tube with flat stock ends shaped to the right angle for the fire...
Guys its not that simple. You need to study the whole EFI operation before you try to do it or you will meet up with a lot of frustration. Here...
500 cfm Edelbrock or 600 Holley vacuum secondary, no larger. Stock 302 at 6000 rpm and 100% efficiency only pumps 575 cfm so subtract 20%,...
I forgot to mention that the vacuum for the dist. needs to come from the ported source on the carb.
Its all in the advance spring setup. There is an adjustable vacuum control also on the market. It take a lot of trial to achive the advance...
You need the hardware from a 84-84 Mustang that had the carb on it. Some larger cars around that time also have the hardware. Do not try to drive...
A number here have done it. Same as Mustang. The spring towers will be removed and some fill-in work to put strength back into the frame areas....
Bogdon, I apoligize for using many numbers without there designations. I assumed you were state side or? I should have known when seeing the...
Stefan, is this the car from Europe?
Separate names with a comma.
