Just seems to me that kink in the middle weakens it considerably...I'd love to check that angle after a year of it being driven
Use a tape measure from some point under the hood and measure from either the uca holes or studs {if the uca is still bolted in on one side} to...
While road racing a Mustang years ago at Bridgehampton i had a rod go through the side of the block blowing the starter motor right off and the...
Check timing first,,,If that's alright then more than likely it's the accelerator pump for the hesitation but there might also be a dashpot on...
Are those holes for getting at the grease fittings?...They're huge!:hmmm:
Must've been a bitch getting a smoothe idle
Don't know for sure but probably....I'm guessing that rubs slightly against a thrust plate....Lay a piece of 400 grit wet sandpaper on something...
Anything is doable....If it were me i would cut the whole floor out of the Shelby with all the mounting points and see if i could graft the whole...
Make sure the PVC valve or valve cover vents aren't plugged up...If so, crankcase pressure could be building up and it'll find any way out it can
I once had a '69 Mustang where the metal cracked where the upper A-Arm holes are...Rare, but worth a look
There's probably a market for the T-10 with the restoration guy's
Why use a T-10 when t5's are way more plentiful and useful?...If you insist, a hydraulic T/O bearing is the way to go although they have to be...
Not the early one's [IMG] No defense needed.......I merely pointed out that a straight bar seems stronger if you're serious about eliminating...
Why?.....Isn't the object, especially when racing or autocrossing to eliminate geometry changes?:huh:
Not to knock your bars or anyone elses but it seems to me that the loop put in to clear a Ford distributor completely renders it useless or less...
Mine?....I see it
This was the set-up on my old mustang....Lot's of adjustability [IMG] [IMG] [IMG]
Maybe obvious but is a longer cable made?
Why not an insulating jacket like the one's i've seen on spark plugs?...Or come up with an aluminum heat shield to go between the cable and...
This is how the one goes from Speedway that Bryant posted, although to me that looks like clearance issues with the top of it hitting the floorpan...
Separate names with a comma.
