Mav****71 are you new to this sort of thig? Better do a lot of reserch on your project. There are a lot of little details you will have to...
.....My 2 cents on Auto Zone. All the stores seem to be on real time computer (SATELLITE) system. Every store will have the same listing...
On the a charge indicator, when the temp in low, a number of things change. The battery does not take a charge as readely as when warm. The...
A check of the catalog shows the possibility of 3 different pumps between 65 and 78. There are left and right lower hose out outlets. Take the...
I went to 4 leaf springs from 3, then lowered by placing 2" blocks between the springs and the axle pads. The U bolts are made locally by a shop....
Look in the Summit catalog for the B&M shift improver kit at about $40. The pan needs to come down, valve body removed and changes made per...
All that is needed is to get a dist. and control box and coil from a 77 Mav and wire it up. You should see improved starting and running over...
I dropped 2" in the rear with 4 leaf springs. I suggest the bottom plates be drilled to 3/8" and have a set of new U bolts made as longer/...
If you want to play with a six, put a built up 300 truck engine in with supercharging. Should be able to get 1 hp per cu in. +. And yes it will...
Hello Jason. Do the reserch, collect the parts, then plan the job. You have been chasing this for a while. Good luck.
If you are talking about an automatic , then the numbers posted are not meaningfull at this time. All Ford ,c4 and c6 auto trans between 72 and...
I am referring to those who have cut a coil and also to use shock extensions on the rear if lowering at least 2" as many have done.
Some cars have a vibration, most don't. In the Comets, the factory had a small flywheel on the front 'U' joint to help. It could be the drive...
Is the vacuuum modulator hose hooked up, and did you make any valve body changes?
You need to check the shock travel. Look at how close the top of the shock body is to the top. Spacers up to 1" can be used to space the top...
It will not hurt anytihing but you really need to effect a repair for ehaust gas reasons. There is a special 'C' clamp available at an auto...
chris, didn't anyone see this when assembling the valve train? The push rod length should be 6.905" in length. Remove one and check it's length....
DON'T. Do it the correct way. You would find sometime that going into a turn fast, the car's front will want to push (not turn), then you could...
fuzz, a couple of heads up things. When considering rear disc, watch the rim size and offset situation and the need for correct front to rear...
Rudy, when my car was carburated, I built a dual cold air intake system using that area and the open area on the other side. On the battery side,...
Separate names with a comma.
