Camber Eliminators

Discussion in 'General Maverick/Comet' started by x72COMETx, Jan 12, 2019.

  1. x72COMETx

    x72COMETx Member

    Joined:
    Jul 23, 2012
    Messages:
    980
    Likes Received:
    125
    Trophy Points:
    133
    Location:
    Vallejo CA
    Vehicle:
    1972 Mercury Comet, 1972 Mercury comet GT, 1975 mercury comet (RIP), 1974 ford maverick (RIP)
  2. dyent

    dyent Member

    Joined:
    Jan 29, 2012
    Messages:
    743
    Likes Received:
    190
    Trophy Points:
    153
    Location:
    vancouver bc
    Vehicle:
    1973 Comet 2 dr., 302 w/AR aluminum heads, Toploader 4 spd, 9" Trac-Lok w/3.70
    Kyle:
    I've had them on my Comet since 1988, well worth the price, never have to worry about knocking the alignment out on the lower control arm, especially if going over pot holes etc.....I think member TOPORANGER? used to fabricate them too, along with his belly bar, export brace bars etc.....although he has not been on the forum since Mar 2017.
    David

    https://www.summitracing.com/int/parts/gls-loc-2/overview/

    http://www.globalwest.net/1967-1968...lignment-problem-solver-kit-locout-loc-2.html
     
    Last edited: Jan 12, 2019
  3. x72COMETx

    x72COMETx Member

    Joined:
    Jul 23, 2012
    Messages:
    980
    Likes Received:
    125
    Trophy Points:
    133
    Location:
    Vallejo CA
    Vehicle:
    1972 Mercury Comet, 1972 Mercury comet GT, 1975 mercury comet (RIP), 1974 ford maverick (RIP)
    Thanks for the reply David

    I will definitely be picking a set up, I was in contact with the person who made the HD belly bars and camber kits and he did have some still in stock but was very hard to get a quote from him on shipping so I eventually gave up, really too bad as I have his Monte Carlo bar, export brace and tie rod sleeves and would have loved to have the rest of his parts

    Thanks Kyle
     
  4. jasonwthompson

    jasonwthompson Member

    Joined:
    Mar 25, 2012
    Messages:
    814
    Likes Received:
    143
    Trophy Points:
    116
    Location:
    Carrollton TX
    Vehicle:
    72 Comet
    I have a set on the Comet as well. Once you get them set, they stay set. I like them much better than the factory eccentrics and will be putting them on the Mustang when the time comes. Get a set that has the holes numbered and stamped.
     

Share This Page