Power Cylinder

Discussion in 'Technical' started by Jett, Jan 2, 2015.

  1. Jett

    Jett Member

    Joined:
    Jul 21, 2012
    Messages:
    218
    Likes Received:
    14
    Trophy Points:
    35
    Location:
    Los Angeles
    Vehicle:
    1976 Mercury Comet L6 250 ci
    hahaha, yes, I mostly remember first names though, there was Ben and Shaun Phelps, Johnny, Lee, all surfers, we were also hanging out with a couple of chicks like Natasha Napier her best friend Michelle...

    Damn that brings back memories! Knowing we were all from roughly 75 to 78.
     
  2. murphsmav

    murphsmav Member

    Joined:
    Apr 15, 2014
    Messages:
    154
    Likes Received:
    12
    Trophy Points:
    30
    Location:
    NSW Australia
    Vehicle:
    1974 Maverick 302 C4 2dr
    Yep, know them. I know the phelps and Johnny Lee in particular especially well. Johnny used to run out the beach with me and my friends and his mum turned out to be the one who gave me my job at Coles and was my boss. They were a few years older than me, especially Johnny but they went to my high school too! I'm friends with Johnny on facebook if you wanna catch up with him!

    Well that is amazing mate. Truly blown me away. That is less than six degrees of separation!
     
  3. Jett

    Jett Member

    Joined:
    Jul 21, 2012
    Messages:
    218
    Likes Received:
    14
    Trophy Points:
    35
    Location:
    Los Angeles
    Vehicle:
    1976 Mercury Comet L6 250 ci
    Crazy world!

    Sadly time and distance made me loose touch with all of them, I did stay in touch for a few years with Shaun and Natasha and that was before "the internet" hahaha
     
  4. Jett

    Jett Member

    Joined:
    Jul 21, 2012
    Messages:
    218
    Likes Received:
    14
    Trophy Points:
    35
    Location:
    Los Angeles
    Vehicle:
    1976 Mercury Comet L6 250 ci
    Hey guys, I'm reviving this one cause I'm finally taking care of that issue and everythin is going fine for removing it, I'm following the step by step link I've got from earlier and I'm at the ball joint seperator part and nothing is moving, any tips?

    Thanks
     

Share This Page