will these frame connectors work??

Discussion in 'Technical' started by hewitt46, Mar 8, 2012.

  1. DC12VOLT

    DC12VOLT Fuel Injected

    Joined:
    Jan 28, 2010
    Messages:
    224
    Likes Received:
    15
    Trophy Points:
    62
    Location:
    Everett, WA
    Vehicle:
    Cream 1971 Maverick
    About how thick in inches is that?
     
  2. maverick1970

    maverick1970 MCG State Rep

    Joined:
    Sep 9, 2003
    Messages:
    7,372
    Likes Received:
    58
    Trophy Points:
    242
    Location:
    Missouri
    Vehicle:
    69 1/2, 70 Maverick and 71 Grabber
    Around 0.120 in
     
  3. DC12VOLT

    DC12VOLT Fuel Injected

    Joined:
    Jan 28, 2010
    Messages:
    224
    Likes Received:
    15
    Trophy Points:
    62
    Location:
    Everett, WA
    Vehicle:
    Cream 1971 Maverick
    Alright, thank you! Thinner than I expected even.
     
  4. Joe Dirt

    Joe Dirt BBF life

    Joined:
    Dec 16, 2008
    Messages:
    4,375
    Likes Received:
    7
    Trophy Points:
    172
    Location:
    Cleveland, TN
    Vehicle:
    1970 ford torino #1
    Over such a short span (less then 4 ft) anything thicker is just added weight the wide base and short walls help with torsional rigidness. 90% of your shelf connectors are the same thickness around 1/8th inch
     
    Last edited: Mar 15, 2012
  5. wardf

    wardf Ward Frahler

    Joined:
    Mar 9, 2002
    Messages:
    1,964
    Likes Received:
    26
    Trophy Points:
    146
    Location:
    Elizabethtown, Ky.
    Vehicle:
    70 maverick
    I would think that 1/8" would be plenty stout enough. In a car with a full frame I bet the frame material is not much thicker inf any than that, I could be wrong.
     

Share This Page