Check to make sure you don't have any terminals on the plug for the ignition switch sticking out. I had this happen when I replaced an ignition...
For sure! dents are a whole lot easier to fix than rust! :)
That's exactly what I want to do! There isn't enough space for the 2¼" gauge panel I want, so I may think about using the 2" ones. I'm in no hurry...
There is an adjustment on the valve. http://mmb.maverick.to/showthread.php?t=8590 Read post 3. Try this first. If you aren't getting the desired...
Sparking means a poor connection! Remove and clean all of the connections to and on the starter, the solenoid, and battery cables. Also do the...
I've found that if you leave off the heater hose that connects on the intake and fill the system until coolant starts coming out the fitting, you...
I have it on dvd. I am an avid sci-fi lover, so of course I enjoyed it! I never get bored with a movie, as you see things that you missed on...
Try mixing a little brake fluid with a little oil. If they mix, you're all set! If not, I know it burns. :)
No matter what type you use, I've found that 2 fingers and a thumb with a nutdriver is good. If you get some seepage after a while, you can always...
:Welcome:, and congrats on a great deal! Unusual for the glass to break from heat when shaded in a garage. I've only seen one Maverick rear glass...
I used ¼" fuel line to hook mine up. It is flexible, but won't kink making the bend around the crossmember. I used a pair of long needle nose...
Personally, I would leave everything as is! You may really want to use the AC before this summer is over! If the blower motor doesn't work, it is...
Did you do the compression test on all of the cylinders? If just #7 and #8 are low, you may have a gasket leak between those two cylinders. I have...
If you are using vacuum advance, do you have it connected to the intake manifold? You will have an increase in manifold pressure when you open the...
When I first looked at the photo of the engine, I thought Wow, they have a special head and intake for the carb to be on the left side! I blew up...
If you have a 3spd shift (column) make sure the car is all the way in reverse. Same with an automatic trans (column) make sure you are all the way...
Put #8 cyl on TDC and see if you can press the rocker arm down by pushing on the pushrod side of it. You can? The lifter has collapsed. If you...
What ignition system are you using? If it's a Duraspark II, the module may be bad causing poor ignition once the engine has run for awhile. If...
I believe that the lower column shaft moves because the upper column is made to "crush" in the event of an accident. That slotted area on the...
The ad says "the fuse panel is the smallest in the industry", so I'm guessing there are still fuses. Also the vibration part I don't quite get, as...
Separate names with a comma.
