i dont even remember where or when this was purchased. it was probably purchased with the engine rebuild kit years ago. this project is moving...
Just getting some closure. We pulled the tranny (again. i swear i could do a full clutch job in under 45 minutes) and called valeo with our clutch...
i know im using the right bell housing i dont know if im using the right pressure plate.
nope car was a I6 3 speed. i am not using the return sprig under the car by the linkage, and i have not messed with the pedal assembly. iv verfied...
all of the above has been done. going to replace the new pressure plate to see if the clutch throw improves. its about the only thing i havent...
so my donor 302/3speed was pulled from a 65 mustang. im not sure if the flywheel was from the 302 or the 289 it replaced. got a few questions...
i spoke with the gentleman on the phone selling the truck. he says it still runs good and no fluids are mixing. all he know is that the dude at...
i have yet to see the truck. i plan on viewing over the weekend.
so you think the pistons and bore wont be damaged?
so its not totally mav specific but it is ford so its relevant. im looking at buying a ford with a 351. fella states that it ran hot and a...
also i have the autokrafter transmission mount.
i have a bit less than 3 inches... maby i was sent the wrong z bar frame mount.
yes, but i had to modify it to make it an inch longer.
the transmission barely fits on the crossmember and the clutch linkage is way off. something is not sitting right got a pic of your z bar mounts?
But those look like correct V8 frame mounts?
they were isntalled so the engine sits as far back as possible. the second pic with the oil filter is the driver side. the oil filter is forward.
Went to install the Autokrafter Z bar thing for the clutch linkage and the frame mount and the motor mount are a mile apart. i noticed im maxed...
Im using the stock 3 speed with a mustang tailshaft.
Do you have the part number for that mccleod throw out bearing?
I read that they had an external slave cylinder in the works but dont know how old that was. Is the imput the same between a topload 3 speed and...
Separate names with a comma.