In the FITECH DOES NOT recommend aluminum line in there installation manual of any type
As for overall performance we are happy good drivability and self learning .. Cons tech help could be better. As for Phoenix fitting is like...
Check with ABS Power Brake in orange Ca. I have one of there units on my 71 Mav. It is a small unit its fit between fire wall and spring tower and...
Will here we go ... I installed a FITEC system on my son's 64 Falcon . It I remember FITEC does not recommend Aluminum line ? ... I used...
Buy the length you need bottom the studs out that way when you remove the valve covers the stud will stay in the head
parts # F6TZ-9B076-AA vapor valve seal E7DZ-9B593 vapor valve E1AZ-9072-B filler neck seal All parts are available on amazon that is where I...
F30 spectra tank , Ford seals , Ford vent all bought on amazon
I did the same thing 71 gold did . In the future I am going with a 134 evaporator
I went with the stock Granada front disc setup and a ABS power booster unit for ABS power brake in Orange Ca.
Bry You get it setup I will be there and will bring my son with his car... Jay
William I have a small number (2 or 3 ) of the ford intermittent wiper boxes with switch ... The boxes I have tested and have tested good but...
What ever length you need check with Coleman Racing Products they have both steel and aluminum shaft with u joints will save you big bucks
If yellow can out reuse the yellow one
Nice job ... I did almost the same thing only on a 8" rear end made my caliper support for mustang caliper and Toyota rotors this all before the...
You are going to need find TDC .. The way I have to due it Remove the #1 spark plug bump engine over with your thumb in spark plug hole until air...
Ha Nuts My new fuel tank sending for my 71 that I just bought from autokrafters is a 3/8"line
Thanks to Dave (55 crownvic ) got my gas hood struts installed ..
As much as possible... If you are going the EFI route then everything from the ECM, wiring harness . remove the charging harness from the head...
Bush are you able to bleed the rear brakes and get a good stream out of both side at the same rate of flow ???? If not take and remove both hard...
After all the engine mods I have done on my EFI 5.0 . Using a chip from one of the Mustang suppliers witch got it running BUT not very good ....
Separate names with a comma.
