I don't think I will have to worry about rods, will never go past 6000, and most likely will make 5500 my rev limit. I just cant believe the...
Well she is together and went with shorty headers due to fitment issues, I was really surprised at the torque down low. I figured it would be a...
no vacuum advance only centrifugal I did have a very slight bit of slack in my timing chain set. Its a cloyes true double roller and maybe had...
I have a freshly rebuilt 357w roller motor, 10:1 static compression, trick flow stage 2 camshaft, older freshened up edelbrock heads, 2.02, 1.6...
decided to go with a 224/232 .550 lift camshaft I decided to add about 0.050 lift and a little duration 224/232 and 286/294 advertised to my...
Nice build WOW!!! I wish I had the money to build a motor like that. I started saving parts and watching Craigs list and ebay for good used...
could be alot of reasons it only revs to 6k? what heads are you running , springs, intake? static compression ratio?headers? fuel injected or...
375tq 400hp I am ok with those numbers and I understand that it is all just guesswork, my heads flow ok numbers at low to mid-lift, backcut...
351w build Why the low torque? I thought with my relatively low advertised duration that torque would be at least higher than HP. Any suggestions...
I have an f4te 351w with the following specs Bored .040 decked to 9.480 h336cp pistons 10:1 compression. .041 quench stock bottom end except rods...
switched charging unit over to g3 alternator for 20$ today Grabbed a small g3 alternator from salvage yard for 14 dollars, with eyelets and some...
I decided stage 2 trick flow would be a little much for my 351w Im gonna go w a stage 1 .499 and .510 221 225 @ .050 and 275 279 @ .006 should be...
no shock tower shave as long as braces fit back on would be the way to go IMO. I think I am going to try the 88660 headers and try not to shave...
hedman 304 stepped headers? some suggestions for 8 inch rear disc donor? Hedman 88304, Has anyone had experience with these headers in a...
offer apperciated I am not sure if Im going power steering or electric or maybe a crazy attempt to put 03 mustang front subframe. busy working on...
WOW just WOW!!!! I looked through most of your gallery and you must have the patience of job, and a god given talent for engineering artistry and...
Borgeson units 500-1000$ look alot like some stock ford units I cant see paying 500 bucks for something that looks an aweful lot like some power...
addressing the stroker issue I have limited funds and a stroker would be my first choice also a 331 for sure due to the need for such short...
no room for changing plugs? my personal choice windsor over cleveland If I rebuild an engine and put mid grade spark plugs in it, I figure I wont...
351 engine dimensions I know 351 ends up being quite a bit taller than 302 at top of intake plenum , but I thought it was only 1 inch wider at...
Separate names with a comma.