I definitely second this, I would be so happy if somebody figured out how to make rear coilovers on a maverick work
A TKO600 with 3.80 rear gears seems to be a decent setup, my install would be closer to $5,000 however I bet because I’d need an entire clutch...
That is a lot of metal cut off but it isn’t TOOO bad, how much do you estimate it cost all said and done? And how does the 3.80 rear gearing feel...
I was just looking at the TKO-500 or 600, how easy was the installation of the 600? How much of the trans tunnel did you have to cut? I’m not...
I have been building a 302 that should be pushing nearly 400hp to the wheels and maybe 350-380 ft/lbs for my ‘72 maverick and I want a manual...
My motor (200 inline 6) will not start or when it does start it only runs for maybe a few seconds and at a very low rpm and runs rough before it...
It's off of a 65 Galaxy I think
Does a "C5ZF H A 4ME" Ford carb fit on a 200 inline 6?
I have a brand new fuel filter and rebuilt the carb so there is no rust in it and i checked the lines and they are good and all the wires are...
I connected the coil directly to the battery and it still ran poorly then died just like it was before i connected the battery
I have checked the positive power to the coil and it is 6 volts while the car is running. The car sputters and dies after only about 20secs and I...
Recently I got in a small wreck and dinged up my car and had to replace my rear axle, as I was doing so I left the keys on and I am pretty sure I...
Should I turn my existing brake drums for $20 each or should I just buy new ones for $30? The car is a 1972 Ford Maverick and has original brake...
Separate names with a comma.