Induction Solutions
Stiff sidewall doesn't have anything to do with high speed stability. They were intended to help launch a heavier stick shift combination. These...
Pinion Angle............ You need a magnetic angle finder. Get the car up in the air but have the weight on each tire as if it is sitting on the...
You have "upgraded springs" yet they're still not enough? Did you do that or this engine builder/dyno guy? I'd get all the timing in by 2500 rpm...
Make sure it has good head gaskets when it goes together. Follow the nitrous company's timing recommendations and use a good fuel. You should be...
Cool. Sucks about the job and shop space though. I hate it when that happens. As I said, never did see an actual LS head done. Only heard...
No, Sizemore's Maverick could not run the modified cylinder head in H/MP. That was for factory heads only. My father ran H/MP. He and Glenn...
Actually, many people have done this in the late '70's/early '80's with both aluminum and cast iron canted valve heads like the Boss 302 or 351...
What about the AJE setup?
Couldn't run the hybrid head in Modified Production. Only in Gas class.
Just say you don't like the engine because you're scared of technology and you don't like the car because it is a race car and you can't build...
"EFI is like baking a cake using precise measurement cups. Carburetors are like baking a cake by throwing flour at a ceiling fan on high speed."...
Both. With the 9 corner idle circuits, three stage power valves and multi-port shooters. :biglaugh:
Belt driven or electric fan? Do you have a full shroud? What temperature does the thermostat open?
Looks like you did that "breezed right past it" thing again. I stated they won't flow worth a damn over .385" lift with a 2.02" valve. Not a...
I've done a TON of flow testing on these heads with various valve sizes. Even moving the chamber wall out to the very edge of the head gasket a...
Deburr the oil drainback holes and the oil filter mounting area.
Forged or Hypereutectic pistons? Steel or aluminum heads? Camshaft duration at .050" and installed centerline?
Electricians are short-circuited between the ears too. Flatulating butthead.
I'm in Oklahoma redesigning a refinery. Weather up here is damned nice today. Front came through on Friday night and it was a bad sumbitch!!!!...
Separate names with a comma.