Very nice work!
Just looked at mine.Looks the same.
I would have to look at mine to see if the ebay one was right.I had 2 locks and may be confused.I can look at it tomorrow.
As i remember it was just a bolt in.But that was about 8 years ago.
I used one from a 1976 Lincoln.MarkIV
The gear the lock goes into is a tooth off.Reset the gear.
I`m 31 years older.
Had similar problem ,Discovered air cleaner was too small.Sounds crazy but it cured mine.
Probably should change the booster also. Brake fluid usually ruins them.
I just had water collecting in the valley of the timing cover. Intake bolts were not tight. Lot easier than a timing cover gasket. Might want to...
Some people should not use tools. Very scary!
That is sick!
After re reading your first post ,I think your problem is at the lower ball joint.If you have tightened it enough to crush the rubber it is wrong....
Welcome from Hingham Ma.
I would check your strut rods.
I am running an 86 Mustang 5.0 HO .I used the stock Mustang pump.
I have an Isuzu Trooper ps box in my Grabber. I believe it is what Borgeson is using by machining the sector shaft for the Maverick pitman arm and...
Looking good Fred!
Just sent Paypal for membership.
What are they,Pictures please.
Separate names with a comma.
