Its a Maverick, Its best to just not question some things... I am short, I find the stock mirror location is lacking. As for there being three...
They were useless in the original location unless you sat in the back seat...
Ghosts...Gremlins...Willa the wisp...Ghost in the machine...Their real, any one who says they aint. Hasen't encountered one yet... PS: Time for...
If its for the 74 you have. Its not a direct replacement. Mustangs were wider and a bit longer. You can make em work but. You will be slicing and...
Espo Spring comes to mind. You can also try Autocrafters. They sell Maverick parts...Please please please...Do not put air shocks on that car the...
Holes were drilled in the body in choice locations. (areas prone to rust) A rust inhibitor was sprayed in the holes to coat the inside of panels....
Squeezed this in behind it just to see if it fit...[IMG]
You state you replaced the points...Did you replace the condenser? If it dies...car dies...Replace it if you haven't. Make sure gap at points is...
Love the hood treatment Joe. That's gonna be a good color for this car, cant wait to see it all cut/buffed.
Karl...Your in virgin territory with the Coyote swap. I would say that since the AJE setup is similar to an SN95 setup you may be on the right...
Looks amazing Joe! Very nicely done indeed....Love it!
Almost looks like the old Bob Glidden color scheme...Very cool find!!
I do like em. They fit well out of the box and stiffened the car up considerably. And the bolt holes are great for plug welds. I did weld em in...
I have built a few of these kits Joe...I just make my own rear springs to raise the ride height. Or you could cheat and just make extensions for...
Good to see you are alive and kickin' Blu. I am guessing from the pic that the Comet is up and running!? (I don't do farce boob either) car looks...
[IMG] Garage is really cool Joe, love it!! Gotta build one myself someday. Since you mentioned the "Little mustang" I was building, figured I...
If you get no fluid out of the bleeder on the wheel cyl while pumping the brake pedal. (and your certain the wheel cyl isn't packed solid with...
If I were you... I would look into commercial and industrial applications for this process. You wont get rich doing it on cars and the like....
Or a collapsed brake hose/pinched hard line.
That car on the trailer looks like it could very well be the original. The good stuff is missing too like the fiberglass doors/frt clip and deck...
Separate names with a comma.
