ford Elite part swappabillity

Discussion in 'Parts Interchange' started by howecomav, Sep 11, 2010.

  1. howecomav

    howecomav Member

    Joined:
    Jul 25, 2010
    Messages:
    123
    Likes Received:
    0
    Trophy Points:
    33
    Location:
    Carthage sd
    Vehicle:
    74 4 door comet getting ready to install 351W in place of 250 i6 spun bearing. And a 74 mav with 302
    here at an auction and Was wondering what parts would interchange off of a 76 elite for breaks and spindles it has no engine thanx for any help?
     
    Last edited: Sep 11, 2010
    howecomav, Sep 11, 2010
    #1
  2. howecomav

    howecomav Member

    Joined:
    Jul 25, 2010
    Messages:
    123
    Likes Received:
    0
    Trophy Points:
    33
    Location:
    Carthage sd
    Vehicle:
    74 4 door comet getting ready to install 351W in place of 250 i6 spun bearing. And a 74 mav with 302
    Will rearend work
     
    howecomav, Sep 11, 2010
    #2
  3. rayzorsharp

    rayzorsharp I "AM" a Maverick!

    Joined:
    Mar 10, 2002
    Messages:
    11,256
    Likes Received:
    65
    Trophy Points:
    298
    Location:
    Grand Bay, Alabama
    Vehicle:
    Three 71 Maverick Grabbers, a 72 302 Sprint, a 73 LDO 2door parts car, a 76 silver v8 Stallion.
    Don't believe anything is going to work off the Elite. Even the rear end would be much too wide. Could be cut down. I feel sure it has a 9" in it but I may even be wrong on that.
     
    rayzorsharp, Sep 11, 2010
    #3
  4. howecomav

    howecomav Member

    Joined:
    Jul 25, 2010
    Messages:
    123
    Likes Received:
    0
    Trophy Points:
    33
    Location:
    Carthage sd
    Vehicle:
    74 4 door comet getting ready to install 351W in place of 250 i6 spun bearing. And a 74 mav with 302
    Ok. thanks its a good thing i lost bid then
     
    howecomav, Sep 11, 2010
    #4

Share This Page